Category of Content
Siting Experience Documents Only
Publication Date
Subject Matter
Keywords
Burnup Credit - Technical Basis for Spent-Fuel Burnup Verification
Burnup Credit - Technical Basis for Spent-Fuel Burnup Verification
Present regulatory practices provide as much burnup credit flexibility as can be currently
expected. Further progress is achievable by incorporating the negative reactivity effects of a
subset of neutron-absorbing fission-product isotopes, and by optimizing the procedural approach
for establishing the burnup characteristics of the spent fuel to be loaded in burnup-creditdesigned
storage and transportation systems. This report describes progress toward developing a
NRC Waste Confidence Rulemaking, Federal Register, 1984, 1990, 1999, and 2008
NRC Waste Confidence Rulemaking, Federal Register, 1984, 1990, 1999, and 2008
NRC Waste Confidence Rulemaking, Federal Register, 1984, 1990, 1999, and 2008
BWR Axial Profile
BWR Axial Profile
Benchmarks for Quantifying Fuel Reactivity Depletion Uncertainty
Benchmarks for Quantifying Fuel Reactivity Depletion Uncertainty
Analytical methods, described in this report, are used to
systematically determine experimental fuel sub-batch
reactivities as a function of burnup. Fuel sub-batch reactivities
are inferred using more than 600 in-core pressurized water
reactor (PWR) flux maps taken during 44 cycles of operation
at the Catawba and McGuire nuclear power plants. The
analytical methods systematically search for fuel sub-batch
reactivities that minimize differences between measured and
computed reaction rates, using Studsvik Scandpower’s
Utilization of the EPRI Depletion Benchmarks for Burnup Credit Validation
Utilization of the EPRI Depletion Benchmarks for Burnup Credit Validation
Pressurized water reactor (PWR) burnup credit validation is
demonstrated using the benchmarks for quantifying fuel reactivity
decrements, published as Benchmarks for Quantifying Fuel Reactivity
Depletion Uncertainty, Electric Power Research Institute (EPRI)
report 1022909. This demonstration uses the depletion module
TRITON (Transport Rigor Implemented with Time-Dependent
Operation for Neutronic Depletion) available in the SCALE 6.1
(Standardized Computer Analyses for Licensing Evaluations) code
Feasibility of Direct Disposal of Dual-Purpose Canisters-Options for Assuring Criticality Control
Feasibility of Direct Disposal of Dual-Purpose Canisters-Options for Assuring Criticality Control
The concept of direct disposal of dual-purpose canisters (DPCs) has not been previously considered
for the Yucca Mountain geologic repository because of concerns, among other reasons,
about degradation of the reactivity-control material over the relatively long period of the repository
analyses. Aluminum-based neutron absorber materials, typically used in DPCs, are not
expected to have sufficient corrosion resistance necessary to retain their integrity over a 10,000+
Burn-up Credit Criticality Safety Benchmark - Phase VII, UO2 Fuel: Study of Spent Fuel Compositions for Long-term Disposal
Burn-up Credit Criticality Safety Benchmark - Phase VII, UO2 Fuel: Study of Spent Fuel Compositions for Long-term Disposal
Analysis of Experimental Data for High Burnup PWR Spent Fuel Isotopic Validation--Calvert Cliffs, Takahama, and Three Mile Island Reactors
Analysis of Experimental Data for High Burnup PWR Spent Fuel Isotopic Validation--Calvert Cliffs, Takahama, and Three Mile Island Reactors
This report is part of a report series designed to document benchmark-quality radiochemical isotopic
assay data against which computer code accuracy can be quantified to establish the uncertainty and bias
associated with the code predictions. The experimental data included in the report series were acquired
from domestic and international programs and include spent fuel samples that cover a large burnup range.
The measurements analyzed in the current report, for which experimental data is publicly available,
NRC SFST ISG-2: Fuel Retrievability
NRC SFST ISG-2: Fuel Retrievability
This Interim Staff Guidance (ISG) provides guidance to the staff for determining if
storage systems to be licensed under 10 CFR Part 72 allow ready retrieval of spent fuel.
This guidance is not a regulation or a requirement.
NRC ISG-1: Classifying the Condition of Spent Nuclear Fuel for Interim Storage and Transportation Based on Function
NRC ISG-1: Classifying the Condition of Spent Nuclear Fuel for Interim Storage and Transportation Based on Function
This Interim Staff Guidance (ISG) provides guidance to the staff on classifying spent nuclear
fuel as either (1) damaged, (2) undamaged, or (3) intact, before interim storage or
transportation. This is not a regulation or requirement and can be modified or superseded by
an applicant with supportable technical arguments.
Revision 2
NRC SFST ISG-3: Post Accident Recovery and Compliance with 10 CFR 72.122(l)
NRC SFST ISG-3: Post Accident Recovery and Compliance with 10 CFR 72.122(l)
Compliance with 10 CFR 72.122(l) has been interpreted to mean that a licensee, during any
point in the storage cycle, must have a means of retrieving and repackaging individual fuel
assemblies even after an accident. The staff has reevaluated this interpretation.
NRC SFST ISG-4: Cask Closure Weld Inspections
NRC SFST ISG-4: Cask Closure Weld Inspections
The closure weld for the outer cover plate for austenitic stainless steel designs may be
inspected using either volumetric or multiple pass dye penetrant techniques subject to the
following conditions:
• Dye penetrant (PT) examination may only be used in lieu of volumetric
examination only on austenitic stainless steels. PT examination should be done
in accordance with ASME Section V, Article 6, “Liquid Penetrant Examination.”
• For either ultrasonic examination (UT) or PT examination, the minimum
NRC SFST ISG-5: Confinement Evaluation
NRC SFST ISG-5: Confinement Evaluation
Several changes have occurred since the issuance of NUREG-1536, “Standard Review Plan
(SRP) for Dry Cask Storage Systems,” that affect the staff’s approach to confinement
evaluation. The attachment to this ISG integrates the current staff approach into a revision of
ISG-5. The highlights of the changes include:
• Reflects October 1998 revisions to 10 CFR 72.104 and 10 CFR 72.106.
• Expands and clarifies acceptance criteria associated with confinement analysis and
acceptance of “leak tight” testing instead of detailed confinement analysis.
NRC SFST ISG-6: Establishing minimum initial enrichment for the bounding design basis fuel assembly(s)
NRC SFST ISG-6: Establishing minimum initial enrichment for the bounding design basis fuel assembly(s)
The Standard Review Plan, NUREG-1536, Chapter 5, Section V, 2 recommends that “the
applicant calculate the source term on the basis of the fuel that will actually provide the
bounding source term,” and states that the applicant should, “either specify the minimum initial
enrichment or establish the specific source terms as operating controls and limits for cask use.”
A specified source term is difficult for most cask users to determine and for inspectors to verify.
NRC SFST ISG-7: Potential Generic Issue Concerning Cask Heat Transfer in a Transportation Accident
NRC SFST ISG-7: Potential Generic Issue Concerning Cask Heat Transfer in a Transportation Accident
Staff raised two major issues concerning the adverse effects of fission gases to the gas-mixture
thermal conductivity in a spent fuel canister in a post accident environment. The two major
concerns were: (1) the reduction of the thermal conductivity of the canister gas by the mixing of
fission gases expelled from failed fuel pins and (2) the resultant temperature and pressure rise
within the canister. Since the fission gas is typically of a lower conductivity than the cover gas,
NRC SFST ISG-8: Burnup Credit in the Criticality Safety Analyses of PWR Spent Fuel in Transportation and Storage Casks
NRC SFST ISG-8: Burnup Credit in the Criticality Safety Analyses of PWR Spent Fuel in Transportation and Storage Casks
Title 10 of the Code of Federal Regulations (10 CFR) Part 71, Packaging and Transportation of
Radioactive Material, and 10 CFR Part 72, Licensing Requirements for the Independent
Storage of Spent Nuclear Fuel, High-Level Radioactive Waste, and Reactor-Related Greater
Than Class C Waste, require that spent nuclear fuel (SNF) remain subcritical in transportation
and storage, respectively. Unirradiated reactor fuel has a well-specified nuclide composition
that provides a straightforward and bounding approach to the criticality safety analysis of
NRC SFST ISG-9: Storage of Components Associated with Fuel Assemblies
NRC SFST ISG-9: Storage of Components Associated with Fuel Assemblies
The purpose of this ISG is to clarify the technical criteria for types of materials that will be |
considered associated with the storage of spent fuel assemblies. While control rods are |
mentioned in the Standard Review Plan as possible contents, specific information and guidance
is lacking.
Revision 1
NRC SFST ISG-10: Alternatives to the ASME Code
NRC SFST ISG-10: Alternatives to the ASME Code
There is no existing American Society of Mechanical Engineers (ASME) Code for the design
and fabrication of spent fuel dry storage casks. Therefore, ASME Code Section III, is
referenced by NUREG-1536, “Standard Review Plan for Dry Cask Storage Systems,” as an
acceptable standard for the design and fabrication of dry storage casks. However, since dry
storage casks are not pressure vessels, ASME Code Section III, cannot be implemented
without allowing some alternatives to its requirements.
Revision 1
NRC SFST ISG-11: Cladding Considerations for the Transportation and Storage of Spent Fuel
NRC SFST ISG-11: Cladding Considerations for the Transportation and Storage of Spent Fuel
The staff has broadened the technical basis for the storage of spent fuel including assemblies
with average burnups exceeding 45 GWd/MTU. This revision to Interim Staff Guidance No. 11
(ISG-11) addresses the technical review aspects of and specifies the acceptance criteria for
limiting spent fuel reconfiguration in storage casks. It modifies the previous revision of the ISG
in three ways: (1) by clarifying the meaning of some of the acceptance criteria contained in
NRC SFST ISG-12: Buckling of Irradiated Fuel Under Bottom End Drop Conditions
NRC SFST ISG-12: Buckling of Irradiated Fuel Under Bottom End Drop Conditions
Fuel rod buckling analyses under bottom end drop conditions have traditionally been performed
to demonstrate integrity of the fuel following a cask drop accident. The methodology described
by Lawrence Livermore National Laboratory (LLNL) to analyze the buckling of irradiated spent
fuel assembly under a bottom end drop in their report UCID-21246 is a simplified approach. It
assumed that buckling occurred when the fuel rod segment between the bottom two spacer
grids reached the Euler buckling limit. The weight of fuel pellets was neglected in the analysis;
NRC SFST ISG-13: Real Individual
NRC SFST ISG-13: Real Individual
The purpose of this guidance is to, (1) clarify the meaning of a real individual as used in 10
CFR 72.104, (2) specify how the applicant may perform dose evaluations beyond the controlled
area for site-specific and general Independent Spent Fuel Storage Installation (ISFSI) licenses,
and (3) clarify standard review plan (SRP) text regarding dose calculations outside the
controlled area.
NRC SFST ISG-14: Supplemental Shielding
NRC SFST ISG-14: Supplemental Shielding
Guidance regarding supplemental shielding that may be installed at an independent
spent fuel storage installation (ISFSI) to meet the requirements of 10 CFR 72.104(a).
NRC SFST ISG-15: MATERIALS EVALUATION
NRC SFST ISG-15: MATERIALS EVALUATION
Due, in part, to a number of material-related issues identified during dry cask storage system
(DCSS) and transportation package application reviews and field implementation, the staff has
recognized the need for specific guidance for the review of materials selected by the applicant
for its DCSS or transportation package.
NRC SFST ISG-16: Emergency Planning
NRC SFST ISG-16: Emergency Planning
Issuance of specific guidance for review of Emergency Plans for facilities licensed pursuant to
10 CFR Part 72 and removal of the reference to Regulatory Guide 3.67, "Standard Format and
Content for Emergency Plans for Fuel Cycle and Materials Facilities," as included in NUREG-
1567, Standard Review Plan for Spent Fuel Dry Storage Facilities (March 2000).