slides - LACBWR Dry Cask Storage
slides - LACBWR Dry Cask Storage
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Slides - 2014 WM Symposia, March 2-6, 2014, Phoenix, AZ
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
The purpose of this engineering calculation is to document the benchmark range, over a variety of parameters, for the validation of the criticality calculations supporting the Monitored Geologic Repository (MGR). This engineering calculation accomplishes this by characterizing the Laboratory Critical Experiments (LCE) and the Pressurized Water Reactor (PWR) Commercial Reactor Criticals (CRC), and summarizing the significant parameters. This engineering calculation supports the Disposal Criticality Analysis Methodology program.
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
The purpose of this design analysis is to determine the accuracy of the SAS2H module of SCALE 4.3 in predicting isotopic concentrations of spent fuel assemblies. The objective is to develop a methodology for modeling assemblies similar to those evaluated within this analysis and to establish the consistency of SAS2H predictions. The results of this analysis may then be applied to future depletion calculations using SAS2H in which no measurements are available. The analytical model employed for this analysis was the SAS2H module of the SCALE sequence.
Presentation to the Nuclear Waste Technical Review Board (NWTRB) in regards to integrating standardization into the nuclear waste management system.
Nuclear Fuels Storage and Transportation Planning Project (NFST) Overview Presentation, 2014 Fuel Cycle Technologies (FCT) Annual Meeting, November 4-6, 2014, Idaho Falls, ID
Slides - Institute of Nuclear Materials Management, 55th Annual Meeting, July 20 – 24, 2014 Atlanta, Georgia
Slides - Institute of Nuclear Materials Management, 55th Annual Meeting, July 20 – 24, 2014 Atlanta, Georgia
Crystalline Repository Project Briefing
Presented to Blue Ribbon Commission on America's Nuclear Future
Site Evaluation and Management Lessons Learned from Yucca Mountain