Category of Content
Siting Experience Documents Only
Publication Date
Subject Matter
Keywords
An Extension of the Validation of SCALE (SAS2H) Isotopic Predictions of PWR Spent Fuel
An Extension of the Validation of SCALE (SAS2H) Isotopic Predictions of PWR Spent Fuel
Isotopic characterization of spent fuel via depletion and decay calculations is necessary for
determination of source terms for subsequent system analyses involving heat transfer, radiation
shielding, isotopic migration, etc. Unlike fresh fuel assumptions typically employed in the criticality
safety analysis of spent fuel configurations, burnup credit applications also rely on depletion and
decay calculations to predict the isotopic composition of spent fuel. These isotopics are used in
Translation of Technical Development on Burn-Up Credit for Spent LWR Fuels
Translation of Technical Development on Burn-Up Credit for Spent LWR Fuels
Technical development on burn-up credit for spent LWR fuels had been performed at JAERI since
1990 under the contract with Science and Technology Agency of Japan entitled ‘Technical Development on
Criticality Safety Management for Spent LWR Fuels.’ Main purposes of this work are to obtain the
experimental data on criticality properties and isotopic compositions of spent LWR fuels and to verify burnup
and criticality calculation codes. In this work three major experiments of exponential experiments for
A Stochastic Method for Estimating the Effect of Isotopic Uncertainties in Spent Nuclear Fuel
A Stochastic Method for Estimating the Effect of Isotopic Uncertainties in Spent Nuclear Fuel
This report describes a novel approach developed at the Oak Ridge National Laboratory
(ORNL) for the estimation of the uncertainty in the prediction of the neutron multiplication factor
for spent nuclear fuel. This technique focuses on burnup credit, where credit is taken in criticality
safety analysis for the reduced reactivity of fuel irradiated in and discharged from a reactor.
Validation methods for burnup credit have attempted to separate the uncertainty associated with
Prediction of the Isotopic Composition of UO2 Fuel from a BWR: Analysis of the DU1 Sample from the Dodewaard Reactor
Prediction of the Isotopic Composition of UO2 Fuel from a BWR: Analysis of the DU1 Sample from the Dodewaard Reactor
As part of a larger program to study mixed-oxide fuel subject to high burnup, some UO2 samples were exposed and analyzed. This report discusses results from the analysis of a UO sample that was burned in a boiling-water reactor (BWR) to approximately 57 GWd/t. The sample
U.S. Regulatory Recommendations for Actinide-Only Burnup Credit in Transport and Storage Casks
U.S. Regulatory Recommendations for Actinide-Only Burnup Credit in Transport and Storage Casks
In July 1999, the U.S. Nuclear Regulatory Commission (NRC) Spent Fuel Project Office
(SFPO) issued Interim Staff Guidance 8 Revision 1 (ISG8R1) to provide recommendations for the use
of burnup credit in storage and transport of pressurized-water reactor (PWR) spent fuel. Subsequent to
the issuance of ISG8R1, the NRC Office of Regulatory Research (RES) has directed an effort to
investigate the technical basis for extending the criteria and recommendations of ISG8R1 to allow
Parametric Analysis of PWR Spent Fuel Depletion Parameters for Long-Term Disposal Criticality Safety
Parametric Analysis of PWR Spent Fuel Depletion Parameters for Long-Term Disposal Criticality Safety
Utilization of burnup credit in criticality safety analysis for long-term disposal of spent
nuclear fuel allows improved design efficiency and reduced cost due to the large mass of fissile
material that will be present in the repository. Burnup-credit calculations are based on depletion
calculations that provide a conservative estimate of spent fuel contents (in terms of criticality
potential), followed by criticality calculations to assess the value of the effective neutron
Assessment of Reactivity Margins and Loading Curves for PWR Burnup-Credit Cask Designs
Assessment of Reactivity Margins and Loading Curves for PWR Burnup-Credit Cask Designs
This report presents studies to assess reactivity margins and loading curves for pressurized water reactor
(PWR) burnup-credit criticality safety evaluations. The studies are based on a generic high-density 32-
assembly cask and systematically vary individual calculational (depletion and criticality) assumptions to
demonstrate the impact on the predicted effective neutron multiplication factor, keff, and burnup-credit
loading curves. The purpose of this report is to provide a greater understanding of the importance of
Assessment of Fission Product Cross-Section Data for Burnup Credit Applications
Assessment of Fission Product Cross-Section Data for Burnup Credit Applications
Past efforts by the Department of Energy (DOE), the Electric Power Research Institute (EPRI), the Nuclear Regulatory Commission (NRC), and others have provided sufficient technical information to enable the NRC to issue regulatory guidance for implementation of pressurized-water reactor (PWR) burnup credit; however, consideration of only the reactivity change due to the major actinides is recommended in the guidance.
Range of Applicability and Bias Determination for Postclosure Criticality of Commercial Spent Nuclear Fuel
Range of Applicability and Bias Determination for Postclosure Criticality of Commercial Spent Nuclear Fuel
The purpose of this calculation report, Range of Applicability and Bias Determination for Postclosure
Criticality of Commercial Spent Nuclear Fuel, is to validate the computational method used to perform
postclosure criticality calculations. The validation process applies the criticality analysis methodology
approach documented in Section 3.5 of the Disposal Criticality Analysis Methodology Topical Report.1
The application systems for this validation consist of waste packages containing transport, aging, and
STARBUCS: A Prototypic SCALE Control Module for Automated Criticality Safety Analyses Using Burnup Credit
STARBUCS: A Prototypic SCALE Control Module for Automated Criticality Safety Analyses Using Burnup Credit
STARBUCS is a new prototypic analysis sequence for performing automated criticality safety analyses of spent fuel systems employing burnup credit. A depletion analysis calculation for each of the burnup-dependent regions of a spent fuel assembly, or other system containing spent fuel, is performed using the ORIGEN-ARP sequence of SCALE. The spent fuel compositions are then used to generate resonance self-shielded cross sections for each region of the problem, which are applied in a three-dimensional criticality safety calculation using the KENO V.a code.
Parametric Study of the Effect of Control Rods for PWR Burnup Credit
Parametric Study of the Effect of Control Rods for PWR Burnup Credit
The Interim Staff Guidance on burnup credit for pressurized water reactor (PWR) spent nuclear fuel (SNF), issued by the United States Nuclear Regulatory Commission's (U.S. NRC) Spent Fuel Project Office, recommends the use of analyses that provide an "adequate representation of the physics" and notes particular concern with the "need to consider the more reactive actinide compositions of fuels burned with fixed absorbers or with control rods fully or partly inserted." In the absence of readily available information on the extent of control rod (CR) usage in U.S.
Sensitivity and Uncertainty Analysis of Commercial Reactor Criticals for Burnup Credit
Sensitivity and Uncertainty Analysis of Commercial Reactor Criticals for Burnup Credit
The purpose of this study is to provide insights into the neutronic similarities that may exist between a
generic cask containing typical spent nuclear fuel assemblies and commercial reactor critical (CRC) state-
points. Forty CRC state-points from five pressurized-water reactors were selected for the study and the
type of CRC state-points that may be applicable for validation of burnup credit criticality safety
calculations for spent fuel transport/storage/disposal systems are identified. The study employed cross-
End Effect keff Cias Curve for Actinide-Only Burnup Credit Casks
End Effect keff Cias Curve for Actinide-Only Burnup Credit Casks
A conservative end effect keff bias curve for actinide-only burnup credit casks is presented
in this paper. Rather than performing axially burnup-dependent analysis, cask designers can, if
they choose to, analyze casks with a uniform axial burnup (at assembly average burnup value) and
add the keff bias values to conservatively bound the actinide-only end effect. Earlier studies
suggested 1-3% increase in keff to account for the end effect, but they included fission products
as well as actinides for their analyses.
Review of Information for Spent Nuclear Fuel Burnup Confirmation
Review of Information for Spent Nuclear Fuel Burnup Confirmation
The Interim Staff Guidance on burnup credit (ISG-8, revision 2) for pressurized-water-reactor spent
nuclear fuel in storage and transport casks, issued in 2002 by the U.S. Nuclear Regulatory Commission’s
Spent Fuel Project Office, recommends an out-of-core burnup measurement to confirm the reactor record
and compliance with the assembly burnup value used for cask loading acceptance. This recommendation
is intended to prevent unauthorized loading (i.e., misloading) of assemblies due to inaccuracies in reactor
Isotopic Analysis of High-Burnup PWR Spent Fuel Samples from the Takahama-3 Reactor
Isotopic Analysis of High-Burnup PWR Spent Fuel Samples from the Takahama-3 Reactor
This report presents the results of computer code benchmark simulations against spent fuel radiochemical assay
measurements from the Kansai Electric Ltd. Takahama-3 reactor published by the Japan Atomic Energy
Research Institute. Takahama-3 is a pressurized-water reactor that operates with a 17 × 17 fuel-assembly design.
Spent fuel samples were obtained from assemblies operated for 2 and 3 cycles and achieved a maximum burnup
of 47 GWd/MTU. Radiochemical analyses were performed on two rods having an initial enrichment of
Evaluation of the French Haut Taux de Combustion (HTC) Critical Experiment Data
Evaluation of the French Haut Taux de Combustion (HTC) Critical Experiment Data
In the 1980s, a series of critical experiments referred to as the Haut Taux de Combustion (HTC)
experiments was conducted by the Institut de Radioprotection et de Sûreté Nucléaire (IRSN) at the
experimental criticality facility in Valduc, France. The plutonium-to- uranium ratio and the isotopic
compositions of both the uranium and plutonium used in the simulated fuel rods were designed to be
similar to what would be found in a typical pressurized-water reactor fuel assembly that initially had an
Evaluation of Cross-Section Sensitivities in Computing Burnup Credit Fission Product Concentrations
Evaluation of Cross-Section Sensitivities in Computing Burnup Credit Fission Product Concentrations
U.S. Nuclear Regulatory Commission Interim Staff Guidance 8 (ISG-8) for burnup credit covers actinides only, a position based primarily on the lack of definitive critical experiments and adequate radiochemical assay data that can be used to quantify the uncertainty associated with fission product credit.
Study of the Effect of Integral Burnable Absorbers for PWR Burnup Credit
Study of the Effect of Integral Burnable Absorbers for PWR Burnup Credit
The Interim Staff Guidance on burnup credit issued by the U.S. Nuclear Regulatory Commission's Spent Fuel Project Office recommends restricting the use of burnup credit to assemblies that have not used burnable absorbers. This restriction eliminates a large portion of the currently discharged spent fuel assemblies from cask loading, and thus severely limits the practical usefulness of burnup credit.
Distribution of Characteristics of LWR Spent Fuel
Distribution of Characteristics of LWR Spent Fuel
The Materials Characterization Center (MCC) at Battelle Pacific Northwest Laboratory (PNL) has the responsibility to select appropriate spent fuel Approved Testing Materials (ATMs) and to characterize, via hot-cell studies, certain detailed properties of the discharged fuel. The purpose of this report isto develop a collective description of the entire spent fuel inventory in terms of various fuel properties relevant to ATMs using information available from the Characteristics Data Base (CDB), which is sponsored by the U.S.
Analysis of Experimental Data for High Burnup PWR Spent Fuel Isotopic Validation--ARIANE and REBUS Programs (UO2 Fuel)
Analysis of Experimental Data for High Burnup PWR Spent Fuel Isotopic Validation--ARIANE and REBUS Programs (UO2 Fuel)
This report is part of a report series designed to document benchmark-quality radiochemical assay data
against which computer code predictions of isotopic composition for spent nuclear fuel can be validated
to establish the uncertainty and bias associated with the code predictions. The experimental data analyzed
in the present report were acquired from two international programs: (1) ARIANE and (2) REBUS, both
coordinated by Belgonucleaire. All measurements include extensive actinide and fission product data of
Parametric Study of the Effect of Burnable Poison Rods for PWR Burnup Credit
Parametric Study of the Effect of Burnable Poison Rods for PWR Burnup Credit
The Interim Staff Guidance on burnup credit (ISG-8) issued by the United States Nuclear Regulatory
Commission’s (U.S. NRC) Spent Fuel Project Office recommends restricting the use of burnup credit to
assemblies that have not used burnable absorbers. This recommended restriction eliminates a large portion
of the currently discharged spent fuel assemblies from cask loading, and thus severely limits the practical
usefulness of burnup credit. In the absence of readily available information on burnable poison rod (BPR)
SCALE-4 Analysis of LaSalle Unit 1 BWR Commercial Reactor Critical Configurations
SCALE-4 Analysis of LaSalle Unit 1 BWR Commercial Reactor Critical Configurations
Five commercial reactor criticals (CRCs) for the LaSalle Unit 1 boiling-water reactor
have been analyzed using KENO V.a, the Monte Carlo criticality code of the SCALE 4 code
system. The irradiated fuel assembly isotopics for the criticality analyses were provided by the
Waste Package Design team at the Yucca Mountain Project in the United States, who performed
the depletion calculations using the SAS2H sequence of SCALE 4. The reactor critical
measurements involved two beginning-of-cycle and three middle-of-cycle configurations. The
K-Infinite Trends with Burnup, Enrichment, and Cooling Time for BWR Fuel Assemblies
K-Infinite Trends with Burnup, Enrichment, and Cooling Time for BWR Fuel Assemblies
This report documents the work performed by ORNL for the Yucca Mountain Project (YMP)
M&O contractor, Framatome Cogema Fuels. The goal of this work was to obtain k values for inf
infinite arrays of flooded boiling-water-reactor (BWR) fuel assemblies as a function of various
burnup/enrichment and cooling-time combinations. These scenarios simulate expected limiting
criticality loading conditions (for a given assembly type) for drift emplacements in a repository. Upon
Analysis of Fresh Fuel Critical Experiments Appropriate for Burnup Credit Validation
Analysis of Fresh Fuel Critical Experiments Appropriate for Burnup Credit Validation
The ANS/ANS-8.1 standard requires that calculational methods used in determining criticality
safety limits for applications outside reactors be validated by comparison with appropriate critical
experiments. This report provides a detailed description of 34 fresh fuel critical experiments and
their analyses using the SCALE-4.2 code system and the 27-group ENDF/B-IV cross-section library.
The 34 critical experiments were selected based on geometry, material, and neutron interaction