The purpose of this design analysis is to determine the accuracy of the SAS2H module of SCALE 4.3 in predicting isotopic concentrations of spent fuel assemblies. The objective is to develop a methodology for modeling assemblies similar to those evaluated within this analysis and to establish the consistency of SAS2H predictions. The results of this analysis may then be applied to future depletion calculations using SAS2H in which no measurements are available.

This report summarizes the results of an initial investigation into the uncertainties associated with the burnup records maintained by nuclear power plants. The results indicate that there is an overall uncertainty of about 2 percent in the burnup records, which must be accounted for in spent fuel applications.

This design calculation is a revision of the previous criticality evaluation of the operations and
processes that are performed in the Aging Facility. It will also demonstrate and assure that the
storage and aging operations to be performed in the Aging Facility meet the criticality safety
design criteria in the Project Design Criteria Document (BSC 2005i, Section 4.9.2.2), and the
nuclear criticality safety requirements described in the SNF Aging System Description Document

Spent Fuel Project Office Interim Staff Guidance - 8

The objective of this calculation is to determine the structural response of the 5-DHLW/DOE (Defense High Level Waste/Department of Energy) SNF (Spent Nuclear Fuel) Short Co-disposal Waste Package (WP) when subjected (while in the horizontal orientation emplaced in the drift) to a collision by a loaded (with WP) Transport and Emplacement Vehicle (TEV) due to an over-run. The scope of this calculation is limited to reporting the calculation results in terms of maximum total stress intensities (SIs) in the outer corrosion barrier (OCB).

This report evaluates the radiological impacts during postulated accidents associated with the
transportation of spent nuclear fuel to the proposed Yucca Mountain repository, using the
RADTRAN 5.5 computer code developed by Sandia National Laboratories. RADTRAN 5.5 can
be applied to estimate the risks associated both with incident-free transportation of radioactive
materials as well as with accidents that may be assumed to occur during transportation. Incidentfree
transportation risks for transport of spent nuclear fuel to Yucca Mountain were evaluated in

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

In the course of producing electrical power in light water.reactors (LWRs), the uranium
fuel accumulates fission products until the fission process is no longer efficient for power
production. At that point the fuel is removed from the reactor and stored in water basins
to allow radioactivity to partially decay before further disposition. This fuel is referred
to as "spent fuel." Although spent fuel as At is discharged from a reactor is intensely
radioactive, it has been stored safely in moderate quantities for decades. Spent fuel could

The objective of this calculation is to evaluate the required minimum burnup as a function of initial boiling water reactor (BWR) assembly enrichment that would permit loading of spent nuclear fuel into the 44 BWR waste package configuration as provided in Attachment IV. This calculation is an application of the methodology presented in ''Disposal Criticality Analysis Methodology Topical Report'' (YMP 2003). The scope of this calculation covers a range of enrichments from 0 through 5.0 weight percent (wt%) U-235, and a burnup range of 0 through 40 GWd/MTU.

This paper presents an evaluation of the amount of burnup credit needed for high-density casks to
transport the current U.S. inventory of commercial spent nuclear fuel (SNF) assemblies. A prototypic
32-assembly cask and the current regulatory guidance were used as bases for this evaluation.
By comparing actual pressurized-water-reactor (PWR) discharge data (i.e., fuel burnup and initial
enrichment specifications for fuel assemblies discharged from U.S. PWRs) with actinide-only-based