Utilization of burnup credit in criticality safety analysis for long-term disposal of spent
nuclear fuel allows improved design efficiency and reduced cost due to the large mass of fissile
material that will be present in the repository. Burnup-credit calculations are based on depletion
calculations that provide a conservative estimate of spent fuel contents (in terms of criticality
potential), followed by criticality calculations to assess the value of the effective neutron

The criticality consequence analysis for pressurized water reactor (PWR) waste packages (WP)
(Civilian Radioactive Waste Management System [CRWMS] Management and Operating
Contractor [M&O] 1997) focused on results obtained by maximizing postulated rates of
reactivity insertion to assure no synergistic reactions could occur among waste packages from
hypothetical criticality events. Other variables potentially influencing the criticality
consequences were held constant during the above referenced analysis. One of those variables

The Nuclear Waste Policy Act of 1982, as amended (the Act), assigns the Federal Government the responsibility for the disposal of spent nuclear fuel and high-level waste. Section 302a of the Act authorized the Secretary to enter into contracts with the owners and generators of commercial spent nuclear fuel and or high level waste. The Standard Contract for Disposal of Spent Nuclear Fuel and or High Level Radioactive Waste (Standard Contract) established the contractual mechanism for the Department's acceptance and disposal of spent nuclear fuel and high level waste.

The objective of this calculation is to evaluate the required minimum burnup as a function of initial boiling water reactor (BWR) assembly enrichment that would permit loading of spent nuclear fuel into the 44 BWR waste package configuration as provided in Attachment IV. This calculation is an application of the methodology presented in ''Disposal Criticality Analysis Methodology Topical Report'' (YMP 2003). The scope of this calculation covers a range of enrichments from 0 through 5.0 weight percent (wt%) U-235, and a burnup range of 0 through 40 GWd/MTU.

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

The objective of this calculation is to determine the structural response of the 5-DHLW/DOE (Defense High Level Waste/Department of Energy) SNF (Spent Nuclear Fuel) Short Co-disposal Waste Package (WP) when subjected (while in the horizontal orientation emplaced in the drift) to a collision by a loaded (with WP) Transport and Emplacement Vehicle (TEV) due to an over-run. The scope of this calculation is limited to reporting the calculation results in terms of maximum total stress intensities (SIs) in the outer corrosion barrier (OCB).

The objective of this calculation is to characterize the nuclear criticality safety concerns
associated with the codisposal of the Department of Energy’s (DOE) Enrico Fermi (EF) Spent
Nuclear Fuel (SNF) in a 5-Defense High-Level Waste (5-DHLW) Waste Package (WP) and
placed in a Monitored Geologic Repository (MGR). The scope of this calculation is limited to
the determination of the effective neutron multiplication factor (keff) for the degraded mode
internal configurations of the codisposal WP. The results of this calculation and those of Ref. 8

The Strategy for the Management and Disposal of Used Nuclear Fuel and High-Level Radioactive Waste is a framework for moving toward a sustainable program to deploy an integrated system capable of transporting, storing, and disposing of used nuclear fuel1 and high-level radioactive waste from civilian nuclear power generation, defense, national security and other activities.

The characteristics of spent nuclear fuel and high-level waste are described, and options for permanent disposal that have been considered are described. These include:
•disposal in a mined geological formation,
•disposal in a multinational repository, perhaps on an unoccupied island,
•by in situ melting, perhaps in underground nuclear test cavities,
•sub-seabed disposal,
•disposal in deep boreholes,
•disposal by melting through ice sheets or permafrost,
•disposal by sending the wastes into space, and

The purpose of this U.S. Department of Energy Nuclear Waste Fund Fee Adequacy Assessment
Report (Assessment) is to present an analysis of the adequacy of the fee being paid by nuclear
power utilities for the permanent disposal of their SNF and HLW by the United States
government.
This Assessment consists of six sections: Section 1 provides historical context and a comparison
to previous fee adequacy assessments; Section 2 describes the system, cost, income, and

This technical report provides an updated summary of the waste package (WP) external criticalityrelated
risk of the plutonium disposition ceramic waste form, which is being developed and
evaluated by the Office of Fissile Materials Disposition of the U.S. Department of Energy (DOE).
The ceramic waste form consists of Pu immobilized in ceramic disks, which would be embedded
in High-Level Waste (HLW) glass in the HLW glass disposal canisters, known as the "can-incanister"

The objective of this analysis is to characterize the criticality safety aspects of a degraded Department of Energy spent nuclear fuel (DOE-SNF) canister containing Massachusetts Institute of Technology (MIT) or Oak Ridge Research (ORR) fuel in the Five-Pack Defense High-Level Waste (DHLW) waste package to demonstrate concept viability related to use in the Mined Geologic Disposal System (MGDS) environment for the postclosure time frame.

In response to the remand of the U.S. Court of Appeals for the District of Columbia Circuit (Minnesota v. NRC, 602 F.2d 412 (1979)), and as a continuation of previous proceedings conducted in this area by NRC (44 Fed. Reg. 61,372), the Commission initiated a generic rulemaking proceeding on October 25, 1979.

Ever since the 1950s, plutonium, used in fas reactors, has been seen as the key to unlocking the vast energy resource contained in the the world's uranium reserves. However, the reductions in expected nuclear reactor installation rates, combined with discovery of additional uranium, have led to a lengthening in the perceived time interval before fast reactors, the most effective users of plutonium, will make large demands on plutonium supplies. THere are several options concerning its use or storage in the meantime.

The purpose of this design analysis is to determine the accuracy of the SAS2H module of SCALE 4.3 in predicting isotopic concentrations of spent fuel assemblies. The objective is to develop a methodology for modeling assemblies similar to those evaluated within this analysis and to establish the consistency of SAS2H predictions. The results of this analysis may then be applied to future depletion calculations using SAS2H in which no measurements are available.

Spent Fuel Project Office Interim Staff Guidance - 8

This study examines concerns raised by the U.S. Department of Energy (DOE) in its planning for transition from active waste site management and remediation to what the department terms “long-term stewardship.” It examines the scientific, technical, and organizational capabilities and limitations that must be taken into account in planning for the long-term institutional management of the department’s numerous waste sites that are the legacy to this country’s nuclear weapons program. It also identifies characteristics and design criteria for effective longterm institutional management.

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

This analysis is prepared by the Mined Geologic Disposal System (MGDS) Waste Package Development (WPD) department to provide an evaluation of the criticality potential within a waste package having some or all of its contents degraded by corrosion and removal of neutron absorbers. This analysis is also intended to provide an estimate of the consequences of any internal criticality, particularly in terms of any increase in radionuclide inventory. These consequence estimates will be used as part of the WPD input to the Total System Performance Assessment.

The purpose of this calculation is to perform partially and fully degraded mode criticality evaluations of plutonium disposed of in a ceramic waste form and emplaced in a Monitored Geologic Repository. The partially degraded mode is represented by the immobilized plutonium ceramic discs piled in the bottom of the waste package (WP) while neutron absorbers begin to leach out of the discs.

The Global Nuclear Energy Partnership (GNEP) Program, a United States (U.S.) Department of
Energy (DOE) program, is intended to support a safe, secure, and sustainable expansion of
nuclear energy, both domestically and internationally. Domestically, the GNEP Program would
promote technologies that support economic, sustained
production of nuclear-generated electricity, while
reducing the impacts associated with spent nuclear fuel
disposal and reducing proliferation risks. DOE envisions
changing the U.S. nuclear energy fuel cycle1 from an

This calculation uses regression (CLReg V1.0 computer code) and non-parametric statistical methods, as specified in References 1 and 12, to develop the critical limit for the 21 Pressurized Water Reactor (PWR) spent nuclear fuel (SNF) waste package (WP) in the proposed geologic repository at Yucca Mountain, Nevada. The critical limit is a limiting value of the effective neutron multiplication factor at which a WP configuration is considered potentially critical.

The purpose of this calculation is to perform a parametric study to determine the effects of fission product leaching, assembly collapse, and iron oxide loss on the reactivity of a waste package (WP) containing mixed oxide (MOX) spent nuclear fuel (SNF). Previous calculations (CRWMS M&O 1998a) have shown that the criticality control features of the WP are adequate to prevent criticality of a flooded WP for all the enrichment/burnup pairs expected for the MOX SNF.