Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

The purpose of this analysis is to evaluate the transient behavior and consequences of a worst case criticality event involving intact pressurized water reactor (PWR) spent nuclear fuel (SNF) in a degraded basket configuration inside a 21 PWR assembly waste package (WP). The objective of this analysis is to demonstrate that the consequences of a worst case criticality event involving intact PWR SNF are insignificant in their effect on the overall radioisotopic inventory in a WP. An internal WP criticality is modeled in a manner analogous to transient phenomena in a nuclear reactor core.

This analysis is prepared by the Mined Geologic Disposal System (MGDS) Waste Package Development Department (WPDD) to determine the viability of the Defense High-Level Waste (DHLW) Glass waste package concept with respect to criticality regulatory requirements in compliance with the goals of the Waste Package Implementation Plan (Ref. 5.1) for conceptual design. These design calculations are performed in sufficient detail to provide a comprehensive comparison base with other design alternatives.

This technical report provides an updated summary of the waste package (WP) external criticalityrelated
risk of the plutonium disposition ceramic waste form, which is being developed and
evaluated by the Office of Fissile Materials Disposition of the U.S. Department of Energy (DOE).
The ceramic waste form consists of Pu immobilized in ceramic disks, which would be embedded
in High-Level Waste (HLW) glass in the HLW glass disposal canisters, known as the "can-incanister"

The purpose of this calculation is to perform partially and fully degraded mode criticality evaluations of plutonium disposed of in a ceramic waste form and emplaced in a Monitored Geologic Repository. The partially degraded mode is represented by the immobilized plutonium ceramic discs piled in the bottom of the waste package (WP) while neutron absorbers begin to leach out of the discs.

Presentation to the Nuclear Waste Technical Review Board (NWTRB) in regards to integrating standardization into the nuclear waste management system.

Nuclear Fuels Storage and Transportation Planning Project (NFST) Overview Presentation, 2014 Fuel Cycle Technologies (FCT) Annual Meeting, November 4-6, 2014, Idaho Falls, ID

Slides - Institute of Nuclear Materials Management, 55th Annual Meeting, July 20 – 24, 2014 Atlanta, Georgia

Slides - Institute of Nuclear Materials Management, 55th Annual Meeting, July 20 – 24, 2014 Atlanta, Georgia

Analytical methods, described in this report, are used to
systematically determine experimental fuel sub-batch
reactivities as a function of burnup. Fuel sub-batch reactivities
are inferred using more than 600 in-core pressurized water
reactor (PWR) flux maps taken during 44 cycles of operation
at the Catawba and McGuire nuclear power plants. The
analytical methods systematically search for fuel sub-batch
reactivities that minimize differences between measured and
computed reaction rates, using Studsvik Scandpower’s

The concept of direct disposal of dual-purpose canisters (DPCs) has not been previously considered
for the Yucca Mountain geologic repository because of concerns, among other reasons,
about degradation of the reactivity-control material over the relatively long period of the repository
analyses. Aluminum-based neutron absorber materials, typically used in DPCs, are not
expected to have sufficient corrosion resistance necessary to retain their integrity over a 10,000+

Progress toward developing a technical basis for a cost-effective burnup credit methodology for
spent nuclear fuel with initial U-235 enrichment up to 5% is presented. Present regulatory
practices provide as much burnup credit flexibility as can be currently expected. Further progress
is achievable by incorporating the negative reactivity effects of a subset of neutron-absorbing
fission product isotopes. Progress also depends on optimizing the procedure for establishing the

The purpose of this analysis is to provide input on the criticality potential of various degraded configurations to an analysis on the probability of a criticality event in a Pressurized Water Reactor (PWR) Advanced Uncanistered Fuel (AUCF) Waste Package (WP).