Category of Content

Siting Experience Documents Only

Publication Date

Country

Keywords

Displaying 1 - 4 of 4

OECD/NEA Burnup Credit Criticality Benchmark, Analysis of Phase II-B Results: Conceptual PWR Spent Fuel Transportation Cask

OECD/NEA Burnup Credit Criticality Benchmark, Analysis of Phase II-B Results: Conceptual PWR Spent Fuel Transportation Cask

Author(s)
Nouri, A.
Publication Date
The OECD/NEA “Burn-up Credit Criticality Benchmark” working group has studied the effect of axial burn-up profile on the criticality of a realistic PWR spent fuel transport cask (Phase II-B). The final results of this benchmark are presented and analysed in this report. Nine basic cases and two additional accident configurations were considered with the following varying parameters: burn-up (0 GWd/t for fresh fuel, 30 and 50 GWd/t), fuel composition (actinides only and actinides with fifteen fission products), axial burn-up discretisation (1 or 9 zones).
criticality pwr fuel transport cask end effect source convergence burnup axial burnup profile

PWR Axial Burnup Profile Analysis

PWR Axial Burnup Profile Analysis

Author(s)
OCRWM
Publication Date

The purpose of this activity is to develop a representative “limiting” axial burnup profile for pressurized water reactors (PWRs), which would encompass the isotopic axial variations caused by different assembly irradiation histories, and produce conservative isotopics with respect to criticality. The effect that the low burnup regions near the ends of spent fuel have on system reactivity is termed the “end-effect”. This calculation will quantify the end-effects associated with Pressurized Water Reactor (PWR) fuel assemblies emplaced in a hypothetical 21 PWR waste package.

criticality commercial spent nuclear fuel end effect storage axial burnup profile isotopic concentrations 21 pwr waste package pwr snf cal-dsu-nu-000012

BWR Axial Profile

BWR Axial Profile

Author(s)
OCRWM
Publication Date

The purpose of this calculation is to develop axial profiles for estimating the axial variation in burnup of a boiling water reactor (BWR) assembly spent nuclear fuel (SNF) given the average burnup of an assembly. A discharged fuel assembly typically exhibits higher burnup in the center and lower burnup at the ends of the assembly. Criticality safety analyses taking credit for SNF burnup must account for axially varying burnup relative to calculations based on uniformly distributed assembly average burnup due to the under-burned tips.

criticality end effect axial burnup profile bwr snf cal-dsu-nu-000005

Report on Implementation of the Obligations under the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management–Second Review Meeting of the Contracting Parties

SED Publication Type

Report on Implementation of the Obligations under the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management–Second Review Meeting of the Contracting Parties

Author
General Secretariat, Council of The European Union
Publication Date

The European Atomic Energy Community (“Euratom”) is a regional organisation, as referred to in Article 39(4) of the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management. It became a party to the Convention on 2 January 2006. This report is submitted in compliance with Articles 30 and 32 of the Convention for the Second Review Meeting of the Contracting Parties, to be held in Vienna from 15 to 26 May 2006.

siting national report joint convention spent fuel management european union radioactive waste management
Disclaimer: Note that this page contains links to external sites. When leaving the CURIE site, please note that the U.S. Department of Energy and Pacific Northwest National Laboratory do not control or endorse the content or ads on these sites.
Sponsored by: