Category of Content

Siting Experience Documents Only

Publication Date

Country

Keywords

Displaying 1 - 5 of 5

WHF and RF Thermal Evaluation

WHF and RF Thermal Evaluation

Author(s)
Bechtel SAIC Company, LLC
Publication Date
The purpose of this analysis is to estimate the peak fuel assembly cladding temperature within the transportation casks that will be received in the WHF and RF, and to compare this value with established temperature limits. Thermally limiting scenarios are evaluated for both normal and off-normal operating conditions, with the off-normal condition defined as a loss of active ventilation. A second purpose of this analysis is to identify a specific room in the surface facilities as thermally limiting of all the rooms, with respect to the potentially highest temperatures on the concrete walls.
thermal analysis transportation yucca mountain heat load

Thermal Loading Study of the TAD Waste Package

Thermal Loading Study of the TAD Waste Package

Author(s)
Bechtel SAIC Company, LLC
Publication Date

The objective of this calculation is to evaluate the peak temperatures due to thermal loading and boundary conditions of the TAD Waste Package design under nominal Monitored Geologic Repository conditions.

thermal analysis transportation, aging and disposal (tad) yucca mountain monitored geologic repository heat load assembly loading

Postclosure Analysis of the Range of Design Thermal Loadings

Postclosure Analysis of the Range of Design Thermal Loadings

Author(s)
Sandia National Laboratories
Publication Date

This report presents a two-phased approach to develop and analyze a “thermal envelope” to represent the postclosure response of the repository to the anticipated range of repository design thermal loadings. In Phase 1 an estimated limiting waste stream (ELWS) is identified and analyzed to determine the extremes of average and local thermal loading conditions. The coldest thermal loading condition is represented by an emplacement drift loaded exclusively with high-level radioactive waste (HLW) and/or defense spent nuclear fuel (DSNF).

thermal analysis yucca mountain postclosure heat load emplacement drift geochemical analysis geomechanical analysis hydrogeologic analysis

National Report of Poland on Compliance with the Obligations of the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management, Polish 3rd National Report as Referred to in Article 32 of the Joint Convention

SED Publication Type

National Report of Poland on Compliance with the Obligations of the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management, Polish 3rd National Report as Referred to in Article 32 of the Joint Convention

Author
Polish National Atomic Energy Agency
Publication Date

This Report has been prepared, according to the guidelines established by the Contracting Parties under Article 29.2(iii), to fulfil the obligations of the Article 32 of the Joint Convention on the Safety of Spent Fuel Management and on the Safety of Radioactive Waste Management, signed by Poland on 30 September 1997 in Vienna, and ratified by the President of the Republic of Poland on 9 March 2000. The corresponding instruments of ratification were deposited with the IAEA on 5 May 2000. The Convention entered into force on 18 June 2001.

siting national report joint convention spent fuel management poland radioactive waste management
Disclaimer: Note that this page contains links to external sites. When leaving the CURIE site, please note that the U.S. Department of Energy and Pacific Northwest National Laboratory do not control or endorse the content or ads on these sites.
Sponsored by: