This paper describes the lessons learned from the U.S. Department of Energy (DOE) transportation of
125 DOE-owned commercial spent nuclear fuel (SNF) assemblies by railroad from the West Valley Demonstration
Project to the Idaho National Engineering and Environmental Laboratory (INEEL). On July 17, 2003, DOE made
the largest single shipment of commercial SNF in the history of the United States. This was a highly visible and
political shipment that used two specially designed Type B transportation and storage casks. This paper describes

In the past, criticality analysis of pressurized water reactor (PWR) fuel stored in racks and casks has assumed that the fuel is fresh with the maximum allowable initial enrichment. If credit is allowed for fuel burnup in the design of casks that are used in the transport of spent light water reactor fuel to a repository, the increase in payload can lead to a significant reduction in the cost of transport and a potential reduction in the risk to the public. A portion of the work has been performed at Oak Ridge National Laboratory (ORNL) in support of the U.S.

This report presents a best-estimate probabilistic risk assessment (PRA) to quantify the frequency of criticality accidents during railroad transportation of spent nuclear fuel casks. The assessment is of sufficient detail to enable full scrutiny of the model logic and the basis for each quantitative parameter contributing to criticality accident scenario frequencies. The report takes into account the results of a 2007 peer review of the initial version of this probabilistic risk assessment, which was published as EPRI Technical Report 1013449 in December 2006.

There have been roughly 2,600 shipments of commercial spent fuel in this country over the past three decades or so. Although this is not an enormous volume by European standards, it is nevertheless significant. These shipments fall into two general categories: individual and "campaign."
There have been a number of individual shipments where lead test assembly fuel was shipped from a reactor to a laboratory for examination. This is an important part of reactor fuel development.

With the Department of Energy’s (DOE) recent submittal of a license application to the U.S. Nuclear Regulatory Commission, the development of Yucca Mountain, Nevada, as a national nuclear waste repository moves one step closer to reality. An operating site at Yucca Mountain could receive between 38-106 rail shipments and 53-89 truck shipments annually over a period of 50 years.

In 1999, the United States Nuclear Regulatory Commission (U.S. NRC) initiated a research program
to support the development of technical bases and guidance that would facilitate the implementation of burnup
credit into licensing activities for transport and dry cask storage. This paper reviews the following major areas of
investigation: (1) specification of axial burnup profiles, (2) assumption on cooling time, (3) allowance for
assemblies with fixed and removable neutron absorbers, (4) the need for a burnup margin for fuel with initial