Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

In the 1980s, a series of critical experiments referred to as the Haut Taux de Combustion (HTC)
experiments was conducted by the Institut de Radioprotection et de Sûreté Nucléaire (IRSN) at the
experimental criticality facility in Valduc, France. The plutonium-to- uranium ratio and the isotopic
compositions of both the uranium and plutonium used in the simulated fuel rods were designed to be
similar to what would be found in a typical pressurized-water reactor fuel assembly that initially had an

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

U.S. Nuclear Regulatory Commission Interim Staff Guidance 8 (ISG-8) for burnup credit covers actinides only, a position based primarily on the lack of definitive critical experiments and adequate radiochemical assay data that can be used to quantify the uncertainty associated with fission product credit.

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

The Interim Staff Guidance on burnup credit for pressurized water reactor (PWR) spent nuclear fuel (SNF), issued by the United States Nuclear Regulatory Commission's (U.S. NRC) Spent Fuel Project Office, recommends the use of analyses that provide an "adequate representation of the physics" and notes particular concern with the "need to consider the more reactive actinide compositions of fuels burned with fixed absorbers or with control rods fully or partly inserted." In the absence of readily available information on the extent of control rod (CR) usage in U.S.

The purpose of this study is to provide insights into the neutronic similarities that may exist between a
generic cask containing typical spent nuclear fuel assemblies and commercial reactor critical (CRC) state-
points. Forty CRC state-points from five pressurized-water reactors were selected for the study and the
type of CRC state-points that may be applicable for validation of burnup credit criticality safety
calculations for spent fuel transport/storage/disposal systems are identified. The study employed cross-

A conservative end effect keff bias curve for actinide-only burnup credit casks is presented
in this paper. Rather than performing axially burnup-dependent analysis, cask designers can, if
they choose to, analyze casks with a uniform axial burnup (at assembly average burnup value) and
add the keff bias values to conservatively bound the actinide-only end effect. Earlier studies
suggested 1-3% increase in keff to account for the end effect, but they included fission products
as well as actinides for their analyses.

The Interim Staff Guidance on burnup credit (ISG-8, revision 2) for pressurized-water-reactor spent
nuclear fuel in storage and transport casks, issued in 2002 by the U.S. Nuclear Regulatory Commission’s
Spent Fuel Project Office, recommends an out-of-core burnup measurement to confirm the reactor record
and compliance with the assembly burnup value used for cask loading acceptance. This recommendation
is intended to prevent unauthorized loading (i.e., misloading) of assemblies due to inaccuracies in reactor

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

The objective of Calculation of Isotopic Bias and Uncertainty for BWR SNF is to quantify the computational bias and uncertainty in the multiplication factor (keff) to be used for Boiling Water Reactor (BWR) spent nuclear fuel (SNF) burn-up credit. The scope of this bias and uncertainty determination covers 38 different radiochemical assay (RCA) spent fuel samples from 14 different fuel assemblies that were irradiated in four different BWRs. The irradiated fuel samples evaluated span an enrichment range of 2.53 weight percent U-235 through 3.95 weight percent U-235.

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

Isotopic characterization of spent fuel via depletion and decay calculations is necessary for
determination of source terms for subsequent system analyses involving heat transfer, radiation
shielding, isotopic migration, etc. Unlike fresh fuel assumptions typically employed in the criticality
safety analysis of spent fuel configurations, burnup credit applications also rely on depletion and
decay calculations to predict the isotopic composition of spent fuel. These isotopics are used in

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

Technical development on burn-up credit for spent LWR fuels had been performed at JAERI since
1990 under the contract with Science and Technology Agency of Japan entitled ‘Technical Development on
Criticality Safety Management for Spent LWR Fuels.’ Main purposes of this work are to obtain the
experimental data on criticality properties and isotopic compositions of spent LWR fuels and to verify burnup
and criticality calculation codes. In this work three major experiments of exponential experiments for

This analysis is prepared by the Mined Geologic Disposal System (MGDS) Waste Package Development Department (WPDD) to determine the viability of the UCF waste package concept with respect to criticality regulatory requirements in compliance with the goals of the Waste Package Implementation Plan5·1 for conceptual design. These design calculations are performed in sufficient detail to provide a comprehensive comparison base with other design alternatives.

This report describes a novel approach developed at the Oak Ridge National Laboratory
(ORNL) for the estimation of the uncertainty in the prediction of the neutron multiplication factor
for spent nuclear fuel. This technique focuses on burnup credit, where credit is taken in criticality
safety analysis for the reduced reactivity of fuel irradiated in and discharged from a reactor.
Validation methods for burnup credit have attempted to separate the uncertainty associated with

As part of a larger program to study mixed-oxide fuel subject to high burnup, some UO2 samples were exposed and analyzed. This report discusses results from the analysis of a UO sample that was burned in a boiling-water reactor (BWR) to approximately 57 GWd/t. The sample

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

In July 1999, the U.S. Nuclear Regulatory Commission (NRC) Spent Fuel Project Office
(SFPO) issued Interim Staff Guidance 8 Revision 1 (ISG8R1) to provide recommendations for the use
of burnup credit in storage and transport of pressurized-water reactor (PWR) spent fuel. Subsequent to
the issuance of ISG8R1, the NRC Office of Regulatory Research (RES) has directed an effort to
investigate the technical basis for extending the criteria and recommendations of ISG8R1 to allow

Five commercial reactor criticals (CRCs) for the LaSalle Unit 1 boiling-water reactor
have been analyzed using KENO V.a, the Monte Carlo criticality code of the SCALE 4 code
system. The irradiated fuel assembly isotopics for the criticality analyses were provided by the
Waste Package Design team at the Yucca Mountain Project in the United States, who performed
the depletion calculations using the SAS2H sequence of SCALE 4. The reactor critical
measurements involved two beginning-of-cycle and three middle-of-cycle configurations. The

Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013

This report documents the work performed by ORNL for the Yucca Mountain Project (YMP)
M&O contractor, Framatome Cogema Fuels. The goal of this work was to obtain k values for inf
infinite arrays of flooded boiling-water-reactor (BWR) fuel assemblies as a function of various
burnup/enrichment and cooling-time combinations. These scenarios simulate expected limiting
criticality loading conditions (for a given assembly type) for drift emplacements in a repository. Upon