Category of Content

Siting Experience Documents Only

Publication Date

Subject Matter

Keywords

Displaying 1 - 25 of 27

Guidance for Creating a Community Benefits Plan for Regional Direct Air Capture Hubs

Guidance for Creating a Community Benefits Plan for Regional Direct Air Capture Hubs

Author(s)
U.S. Department of Energy Office of Clean Energy Demonstrations
Publication Date

This document is intended to provide supplemental information to assist applicants developing a Community Benefits Plan (CBP) for the Regional Direct Air Capture Hubs. As shown in the graphic to the right, Community Benefits Plans are based on a set of four core interdependent policy priorities: engaging communities and labor; investing in America's workforce; advancing diversity, equity, inclusion, and accessibility; and implementing Justice40.

Policies for Achieving Energy Justice in Society: Best Practices for Applying Solar Energy Technologies to Low-Income Housing

Policies for Achieving Energy Justice in Society: Best Practices for Applying Solar Energy Technologies to Low-Income Housing

Author(s)
Center for Energy and Environmental Policy - University of Delaware
Publication Date

Studies indicate that the energy burden — energy costs as a percentage of annual family income — on low-income families is inordinately high, compared to that of the rest of the population. Rising fuel costs exacerbate this problem. Residential solar energy systems can help address this situation by furnishing a price-stable energy source with the added benefit of reduced greenhouse gas emissions. However, without appropriate incentives, these systems are prohibitively expensive for low-income families.

Dose Rate Calculations for the 2-MCO/2-DHLW Waste Package

Dose Rate Calculations for the 2-MCO/2-DHLW Waste Package

Author(s)
OCRWM
Publication Date
The objective of this calculation is to determine the dose rates on the external surfaces of the waste package (WP) containing two Hanford defense high-level waste (DHLW) glass canisters and two Hanford multi-canister overpacks (MCO). Each MCO is loaded with the N Reactor spent nuclear fuel (SNF). The information provided by the sketches attached to this calculation is that of the potential design for the WP type considered in this calculation.
high level waste radiation protection storage hanford site 2-mco/2-dhlw dose calculation multi-canister overpack defense

WHF and RF Thermal Evaluation

WHF and RF Thermal Evaluation

Author(s)
Bechtel SAIC Company, LLC
Publication Date
The purpose of this analysis is to estimate the peak fuel assembly cladding temperature within the transportation casks that will be received in the WHF and RF, and to compare this value with established temperature limits. Thermally limiting scenarios are evaluated for both normal and off-normal operating conditions, with the off-normal condition defined as a loss of active ventilation. A second purpose of this analysis is to identify a specific room in the surface facilities as thermally limiting of all the rooms, with respect to the potentially highest temperatures on the concrete walls.
thermal analysis transportation yucca mountain heat load
Disclaimer: Note that this page contains links to external sites. When leaving the CURIE site, please note that the U.S. Department of Energy and Pacific Northwest National Laboratory do not control or endorse the content or ads on these sites.
Sponsored by: