Category of Content
Siting Experience Documents Only
Publication Date
Subject Matter
Country
Keywords
An Extension of the Validation of SCALE (SAS2H) Isotopic Predictions of PWR Spent Fuel
An Extension of the Validation of SCALE (SAS2H) Isotopic Predictions of PWR Spent Fuel
Isotopic characterization of spent fuel via depletion and decay calculations is necessary for
determination of source terms for subsequent system analyses involving heat transfer, radiation
shielding, isotopic migration, etc. Unlike fresh fuel assumptions typically employed in the criticality
safety analysis of spent fuel configurations, burnup credit applications also rely on depletion and
decay calculations to predict the isotopic composition of spent fuel. These isotopics are used in
Management of Commercial High Level and Transuranium Contaminated Radioactive Waste
Management of Commercial High Level and Transuranium Contaminated Radioactive Waste
This report summarizes the results of EPA's review of the AEC
draft environmental statement, "Management of Commercial High-Level
and Transuranium-Contaminated Radioactive Waste" (WASH-1539). The
means by which high-level and long-lived radioactive wastes are
managed constitutes one of the most important questions upon which
the public acceptability of nuclear power, with its social and economic
benefits, will be determined. While the generation of power by
nuclear means offers certain benefits from the environmental viewpoint,
SAS2H Analysis of Radiochemical Assay Samples from Obrigheim PWR Reactor
SAS2H Analysis of Radiochemical Assay Samples from Obrigheim PWR Reactor
The purpose of this design analysis is to determine the accuracy of the SAS2H module of SCALE 4.3 in predicting isotopic concentrations of spent fuel assemblies. The objective is to develop a methodology for modeling assemblies similar to those evaluated within this analysis and to establish the consistency of SAS2H predictions. The results of this analysis may then be applied to future depletion calculations using SAS2H in which no measurements are available.
Criticality Evaluation of Intact and Degraded PWR WPs Containing MOX SNF
Criticality Evaluation of Intact and Degraded PWR WPs Containing MOX SNF
The purpose of this calculation is to perform criticality evaluations for mixed oxide spent nuclear fuel in 12 and 21 pressurized water reactor waste packages for both intact and degraded configurations. The MOX assembly design considered in previous studies on Pu disposition in commercial reactors is based on the Westinghouse 17x17 Vantage 5 assembly (Ref. 7.2). Depletion analyses of four Pu enrichment and burnup(expressed as gigawatt days/metric ton heavy metal; GWd/MTHM)) combinations were performed in Ref. 7.4.
A Stochastic Method for Estimating the Effect of Isotopic Uncertainties in Spent Nuclear Fuel
A Stochastic Method for Estimating the Effect of Isotopic Uncertainties in Spent Nuclear Fuel
This report describes a novel approach developed at the Oak Ridge National Laboratory
(ORNL) for the estimation of the uncertainty in the prediction of the neutron multiplication factor
for spent nuclear fuel. This technique focuses on burnup credit, where credit is taken in criticality
safety analysis for the reduced reactivity of fuel irradiated in and discharged from a reactor.
Validation methods for burnup credit have attempted to separate the uncertainty associated with
Standards & Regulations for the Geologic Disposal of Spent Nuclear Fuel and High-Level Waste
Standards & Regulations for the Geologic Disposal of Spent Nuclear Fuel and High-Level Waste
This paper draws on my experience as a reviewer of the scientific programs and performance assessments of the geological repository for transuranic waste at the Waste Isolation Pilot Plant in New Mexico and the proposed repository for spent nuclear fuel and high-level waste at Yucca Mountain in Nevada. In addition, I have served on numerous committees of the National Research Council that have addressed many aspects of nuclear waste management.
Probability of a PWR Uncanistered Fuel Waste Package Postclosure Criticality
Probability of a PWR Uncanistered Fuel Waste Package Postclosure Criticality
The purpose of this calculation is to estimate the probability of criticality in a pressurized water reactor (PWR) uncanistered fuel waste package during the postclosure phase of the repository as a function of various waste package material, loading, and environmental parameters. Parameterization on the upper subcritical limit that is used to define the threshold for criticality will also be performed. The possibility of waste package misload due to human or equipment error during preclosure is also considered in estimating the postclosure criticality probability.
Japan’s Spent Fuel and Plutonium Management Challenges
Japan’s Spent Fuel and Plutonium Management Challenges
Japan’s spent fuel management and fuel cycle programs are now at a critical stage. Its first commercial-scale reprocessing plant, at Rokkasho Village, will soon start full-scale operation.
Managing the Nation's Commercial High-Level Radioactive Waste
Managing the Nation's Commercial High-Level Radioactive Waste
This report presents the findings and conclusions of OTA's analysis of Federal policy
for the management of commercial high-level radioactive waste. It represents a major update
and expansion of the analysis presented to Congress in our summary report, Managing
Commercial High-Level Radioactive Waste, published in April of 1982 during the
debate leading to passage of the Nuclear Waste Policy Act of 1982 (NWPA). This new
report is intended to contribute to the implementation of NWPA, and in particular to
Options for Developing Public and Stakeholder Engagement for the Storage and Management of Spent Nuclear Fuel (SNF) and High Level Waste (HLW) in the United States
Options for Developing Public and Stakeholder Engagement for the Storage and Management of Spent Nuclear Fuel (SNF) and High Level Waste (HLW) in the United States
This report puts forth a number of options and recommendations for how to engage
stakeholders and other members of the public in the storage and management of spent
nuclear fuel and high level waste in the United States. The options are generated from a
scientific review of existing publications proposing criteria for assessing past efforts to
engage publics and stakeholders in decision-making about risky technologies. A set of
nine principles are derived for evaluating cases of public and stakeholder engagement with
Management of Commercially Generated Radioactive Waste
Management of Commercially Generated Radioactive Waste
In the course of producing electrical power in light water.reactors (LWRs), the uranium
fuel accumulates fission products until the fission process is no longer efficient for power
production. At that point the fuel is removed from the reactor and stored in water basins
to allow radioactivity to partially decay before further disposition. This fuel is referred
to as "spent fuel." Although spent fuel as At is discharged from a reactor is intensely
radioactive, it has been stored safely in moderate quantities for decades. Spent fuel could
Parametric Analysis of PWR Spent Fuel Depletion Parameters for Long-Term Disposal Criticality Safety
Parametric Analysis of PWR Spent Fuel Depletion Parameters for Long-Term Disposal Criticality Safety
Utilization of burnup credit in criticality safety analysis for long-term disposal of spent
nuclear fuel allows improved design efficiency and reduced cost due to the large mass of fissile
material that will be present in the repository. Burnup-credit calculations are based on depletion
calculations that provide a conservative estimate of spent fuel contents (in terms of criticality
potential), followed by criticality calculations to assess the value of the effective neutron
Sensitivity Study of Reactivity Consequences to Waste Package Egress Area
Sensitivity Study of Reactivity Consequences to Waste Package Egress Area
The criticality consequence analysis for pressurized water reactor (PWR) waste packages (WP)
(Civilian Radioactive Waste Management System [CRWMS] Management and Operating
Contractor [M&O] 1997) focused on results obtained by maximizing postulated rates of
reactivity insertion to assure no synergistic reactions could occur among waste packages from
hypothetical criticality events. Other variables potentially influencing the criticality
consequences were held constant during the above referenced analysis. One of those variables
Acceptance Priority Ranking & Annual Capacity Report
Acceptance Priority Ranking & Annual Capacity Report
The Nuclear Waste Policy Act of 1982, as amended (the Act), assigns the Federal Government the responsibility for the disposal of spent nuclear fuel and high-level waste. Section 302a of the Act authorized the Secretary to enter into contracts with the owners and generators of commercial spent nuclear fuel and or high level waste. The Standard Contract for Disposal of Spent Nuclear Fuel and or High Level Radioactive Waste (Standard Contract) established the contractual mechanism for the Department's acceptance and disposal of spent nuclear fuel and high level waste.
44-BWR WASTE PACKAGE LOADING CURVE EVALUATION
44-BWR WASTE PACKAGE LOADING CURVE EVALUATION
The objective of this calculation is to evaluate the required minimum burnup as a function of initial boiling water reactor (BWR) assembly enrichment that would permit loading of spent nuclear fuel into the 44 BWR waste package configuration as provided in Attachment IV. This calculation is an application of the methodology presented in ''Disposal Criticality Analysis Methodology Topical Report'' (YMP 2003). The scope of this calculation covers a range of enrichments from 0 through 5.0 weight percent (wt%) U-235, and a burnup range of 0 through 40 GWd/MTU.
Assessment of Fission Product Cross-Section Data for Burnup Credit Applications
Assessment of Fission Product Cross-Section Data for Burnup Credit Applications
Past efforts by the Department of Energy (DOE), the Electric Power Research Institute (EPRI), the Nuclear Regulatory Commission (NRC), and others have provided sufficient technical information to enable the NRC to issue regulatory guidance for implementation of pressurized-water reactor (PWR) burnup credit; however, consideration of only the reactivity change due to the major actinides is recommended in the guidance.
slides - Operating Experience, Session I, Cask Cranes
slides - Operating Experience, Session I, Cask Cranes
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
TEV Collision with an Emplaced 5-DHLW/DOE SNF Short Co-Disposal Waste Package
TEV Collision with an Emplaced 5-DHLW/DOE SNF Short Co-Disposal Waste Package
The objective of this calculation is to determine the structural response of the 5-DHLW/DOE (Defense High Level Waste/Department of Energy) SNF (Spent Nuclear Fuel) Short Co-disposal Waste Package (WP) when subjected (while in the horizontal orientation emplaced in the drift) to a collision by a loaded (with WP) Transport and Emplacement Vehicle (TEV) due to an over-run. The scope of this calculation is limited to reporting the calculation results in terms of maximum total stress intensities (SIs) in the outer corrosion barrier (OCB).
Enrico Fermi Fast Reactor Spent Nuclear Fuel Criticality Calculations: Degraded Mode
Enrico Fermi Fast Reactor Spent Nuclear Fuel Criticality Calculations: Degraded Mode
The objective of this calculation is to characterize the nuclear criticality safety concerns
associated with the codisposal of the Department of Energy’s (DOE) Enrico Fermi (EF) Spent
Nuclear Fuel (SNF) in a 5-Defense High-Level Waste (5-DHLW) Waste Package (WP) and
placed in a Monitored Geologic Repository (MGR). The scope of this calculation is limited to
the determination of the effective neutron multiplication factor (keff) for the degraded mode
internal configurations of the codisposal WP. The results of this calculation and those of Ref. 8
SAS2H Analysis of Radiochemical Assay Samples from Calvert Cliffs PWR Reactor
SAS2H Analysis of Radiochemical Assay Samples from Calvert Cliffs PWR Reactor
The purpose of this design analysis is to determine the accuracy of the SAS2H module of SCALE 4.3 in predicting isotopic concentrations of spent fuel assemblies. The objective is to develop a methodology for modeling assemblies similar to those evaluated within this analysis and to establish the consistency of SAS2H predictions. The results of this analysis may then be applied to future depletion calculations using SAS2H in which no measurements are available.
slides - Cumulative Impact of Industry and NRC Actions
slides - Cumulative Impact of Industry and NRC Actions
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Nuclear Criticality Calculations for Canister-Based Facilities - Commercial SNF
Nuclear Criticality Calculations for Canister-Based Facilities - Commercial SNF
The results of the MCNP criticality safety calculations described in this document are presented in Section 7.1. Based on the results presented attributes of the TAD canister-based systems that are important to ensuring their subcriticality are established. These attributes can be categorized according to the criticality control parameter that is impacted. Based on the categorization presented it is seen that moderation control is the underlying criticality control parameter for TAD canister-based systems containing CSNF with a maximum initial enrichment of 5 wt.% 235U/U.
Nuclear Power And Proliferation Resistance: Securing Benefits, Limiting Risk
Nuclear Power And Proliferation Resistance: Securing Benefits, Limiting Risk
Goal: Secure the Benefits, Limit the Risk
The extent to which nuclear power will be a broadly accepted option for meeting future global energy needs depends upon cost, safety, waste management and the ability to limit the associated proliferation risks. While all four considerations are important, this report exclusively examines proliferation risks.
NEI Integrated Used Nuclear Fuel Management Strategy
NEI Integrated Used Nuclear Fuel Management Strategy
The nuclear energy industry is committed to legislative reform to create a sustainable, integrated program for federal government management of the Department of Energy’s (DOE) high-level radioactive waste and commercial used nuclear fuel.