slides - NRC Management Perspectives
slides - NRC Management Perspectives
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
Presented at the NEI Used Fuel Management Conference, St. Petersburg, FL, May 7-9, 2013
The objective of these calculations is to perform intact and degraded mode criticality evaluations of the Department of Energy's (DOE) Three Mile Island- Unit 2 (TMI-2) spent nuclear fuel (SNF) in canisters. This analysis evaluates codisposal in a 5-Defense High-Level Waste (5-DHLW/DOE SNF) Long Waste Package (Civilian Radioactive Waste Management System Management and Operating Contractor [CRWMS M&O] 2000b, Attachment V), which is to be placed in a potential monitored geologic repository (MGR).
The Monitored Geologic Repository (MGR) Waste Package Department of the Civilian Radioactive Waste Management System Management & Operating contractor (CRWMS M&O) performed calculations to provide input for disposal of spent nuclear fuel (SNF) from the Shippingport Light Water Breeder Reactor (LWBR) (Ref. 1). The Shippingport LWBR SNF has been considered for disposal at the potential Yucca Mountain site.
This analysis is prepared by the Mined Geologic Disposal System (MGDS) Waste Package Development (WPD) department to provide an evaluation of the criticality potential within a waste package having some or all of its contents degraded by corrosion and removal of neutron absorbers. This analysis is also intended to provide an estimate of the consequences of any internal criticality, particularly in terms of any increase in radionuclide inventory. These consequence estimates will be used as part of the WPD input to the Total System Performance Assessment.
The purpose of this calculation is to perform partially and fully degraded mode criticality evaluations of plutonium disposed of in a ceramic waste form and emplaced in a Monitored Geologic Repository. The partially degraded mode is represented by the immobilized plutonium ceramic discs piled in the bottom of the waste package (WP) while neutron absorbers begin to leach out of the discs.
The purpose of this activity is to develop a representative “limiting” axial burnup profile for pressurized water reactors (PWRs), which would encompass the isotopic axial variations caused by different assembly irradiation histories, and produce conservative isotopics with respect to criticality. The effect that the low burnup regions near the ends of spent fuel have on system reactivity is termed the “end-effect”. This calculation will quantify the end-effects associated with Pressurized Water Reactor (PWR) fuel assemblies emplaced in a hypothetical 21 PWR waste package.
The Disposal Subcommittee of the Blue Ribbon Commission on America’s Nuclear Future (BRC) addressed a wide-ranging set of issues, all bearing directly on the central question: “How can the United States go about establishing one or more disposal sites for high-level nuclear wastes in a manner and within a timeframe that is technically, socially, economically, and politically acceptable?”
The purpose of this analysis is to identify, extract, and reformat weather (meteorological) data that is appropriate for use as input to an infiltration model, within the Yucca Mountain region. The analysis uses relevant meteorological data (e.g., precipitation and temperature) from source stations, and reformats or converts the data into a form suitable for the generation of meteorological conditions for a 10,000-year future climate in the Yucca Mountain region.
The repository design includes a drip shield (BSC 2004 [DIRS 168489]) that provides protection for the waste package both as a barrier to seepage water contact and a physical barrier to potential rockfall.
The purpose of the process-level models developed in this report is to model dry oxidation, general corrosion, and localized corrosion of the drip shield plate material, which is made of Ti Grade 7. This document is prepared ·according to Technical Work Plan For: Regulatory Integration Modeling and Analysis of the Waste Form and Waste Package (BSC 2004 [DIRS 171583]).
The Global Nuclear Energy Partnership (GNEP) Program, a United States (U.S.) Department of
Energy (DOE) program, is intended to support a safe, secure, and sustainable expansion of
nuclear energy, both domestically and internationally. Domestically, the GNEP Program would
promote technologies that support economic, sustained
production of nuclear-generated electricity, while
reducing the impacts associated with spent nuclear fuel
disposal and reducing proliferation risks. DOE envisions
changing the U.S. nuclear energy fuel cycle1 from an
This calculation uses regression (CLReg V1.0 computer code) and non-parametric statistical methods, as specified in References 1 and 12, to develop the critical limit for the 21 Pressurized Water Reactor (PWR) spent nuclear fuel (SNF) waste package (WP) in the proposed geologic repository at Yucca Mountain, Nevada. The critical limit is a limiting value of the effective neutron multiplication factor at which a WP configuration is considered potentially critical.
Slides - WM2014 Symposia, March 2-6, 2014, Phoenix, AZ
The Reactor and Fuel Cycle Technology Subcommittee was formed to respond to the charge—set forth in the charter of the BRC—to evaluate existing fuel cycle technologies and R&D programs in terms of multiple criteria.
The purpose of this calculation is to document the validity of the commercial reactor criticals (CRC) as a source for a spent nuclear fuel benchmark, and to characterize the neutronic similarities between a CRC and a waste package (WP). This report illustrates comparisons of neutron spectrum and the effects on criticality arising from physical differences between a WP and a CRC. This report is an engineering calculation supporting the development of the disposal criticality analysis methodology, performed under Quality Administrative Procedure (QAP)-3-15 Revision 0.
This analysis is prepared by the Mined Geologic Disposal System (MGDS) Waste Package Development Department (WPDD) to compare the criticality potential of Westinghouse 17x17 mixed oxide (MOX) PWR fuel with the Design Basis spent nuclear fuel (SNF) analyzed previously (Ref. 5.1, 5.2). The basis of comparison will be the conceptual design Multi- Purpose Canister (MPC) PWR waste package concepts.
This report documents the work performed by ORNL for the Yucca Mountain Project (YMP)
M&O contractor, Framatome Cogema Fuels. The goal of this work was to obtain k values for inf
infinite arrays of flooded boiling-water-reactor (BWR) fuel assemblies as a function of various
burnup/enrichment and cooling-time combinations. These scenarios simulate expected limiting
criticality loading conditions (for a given assembly type) for drift emplacements in a repository. Upon
The "Summary Report of Commercial Reactor Criticality Data for McGuire Unit 1" contains the detailed information necessary to perform commercial reactor criticality (CRC) analyses for the McGuire Unit 1 reactor.
The ANS/ANS-8.1 standard requires that calculational methods used in determining criticality
safety limits for applications outside reactors be validated by comparison with appropriate critical
experiments. This report provides a detailed description of 34 fresh fuel critical experiments and
their analyses using the SCALE-4.2 code system and the 27-group ENDF/B-IV cross-section library.
The 34 critical experiments were selected based on geometry, material, and neutron interaction
This report, Summary Report of Laboratory Critical Experiment Analyses Performed for the Disposal Criticality Analysis Methodology, contains a summary of the laboratory critical experiment (LCE) analyses used to support the validation of the disposal criticality analysis methodology.
The purpose of this calculation is to perform a parametric study to determine the effects of fission product leaching, assembly collapse, and iron oxide loss on the reactivity of a waste package (WP) containing mixed oxide (MOX) spent nuclear fuel (SNF). Previous calculations (CRWMS M&O 1998a) have shown that the criticality control features of the WP are adequate to prevent criticality of a flooded WP for all the enrichment/burnup pairs expected for the MOX SNF.
The purpose of this calculation is to apply the process described in the Preclosure Criticality Analysis Process Report (Ref. 2.2.12) to establish the bias for keff calculations performed for commercial nuclear fuels using the MCNP code system. This bias will be used in criticality safety analyses as part of the basis for establishing the upper subcritical limit (USL). This calculation also defines the range of applicability (ROA) for which the bias may be used directly without need to consider additional penalties on the USL.
The requirements of ANSI/ANS-8.1 specify that calculational methods for away-from-reactor
criticality safety analyses be validated against experimental measurements. If credit is to be taken for
the reduced reactivity of burned or spent fuel relative to its original "fresh" composition, it is
necessary to benchmark computational methods used in determining such reactivity worth against
spent fuel reactivity measurements. This report summarizes a portion of the ongoing effort to